2000W Continuous Fiber Laser Cutting Machine

2000W Continuous Fiber Laser Cutting Machine

 

Fiber optic cutting machine configuration：

 

Technical Parameter：

 

Equipment introduction

1: This machine is mainly designed for high-speed laser processing of thin plates, with stable operation, mature technology, and high cutting efficiency

2: The device host has good rigidity and high strength. The base is made of Jinan green marble, and the crossbeam is made of extruded aluminum profiles, which have good acceleration performance and effectively prevent structural deformation,

3: Control part: An open motion control platform that integrates motion control, PLC, and HMI, which can be effectively applied to various laser processing. The EtherCAT bus based front-end control system greatly improves the flexibility and scalability of the equipment

Equipment working environment requirements:

Working environment temperature -10~45 ℃, relative humidity<90%, no condensation, surrounding environment: ventilated, no significant vibration, power supply voltage 380 ± 5%

The overall power of the machine is 5KW

Warranty and after-sales service: One year warranty for the entire machine and two years warranty for the laser; The response time for maintenance services is within 24 hours.

Equipment operating environment temperature: recommended 0 ℃ -40 ℃ ; Laser must not condense; Keep the cooling water clean; Reliable grounding.

Accessories：

 

INSTALLATION REQUIREMENTS：

1. On site distribution cabinet: 220V, 50Hz, three-phase four wire, capacity not less than 40 KVA, with short-circuit protection, etc.

2. The device should be equipped with a dedicated grounding, with a grounding resistance not exceeding 4 Ω.

3. Provide necessary lifting equipment and personnel.

4. Provide materials such as steel plates required for on-site equipment debugging. .

5. Provide temporary access cards for debugging personnel.

6. The auxiliary conditions required for the normal operation of laser cutting equipment:

6.1 Cutting auxiliary gases (N2, O2);

6.2 Water free and oil-free compressed air or nitrogen supply system.

7. Equipment space and foundation requirements: The foundation is made of concrete with a minimum thickness of 200 mm; there are no seismic sources or shock-absorbing grooves around the foundation.